Beautiful Jade shows how to check the Compression on an Engine – Video

Beautiful Girls Doing Auto Repairs

Compression

In this Video Beautiful Jade shows how to check the Compression on an Engine. Is Important to know how to perform this Test, specially because there are times when a Cylinder Misfire is misdiagnosed and a novice could spend money on Ignition Coil, Injector etc. Only to find out later on that the Misfire was caused by Low Compression on a particular Cylinder. Note: Anything under 100 Psi on any Cylinder will cause hesitation, specially at idle, and of course poor Engine Performance.

 

How to Do a Compression Test

A compression test reveals the condition of your engine’s valves, its valve seats, and piston rings and whether these parts are wearing evenly. Healthy engines should have compression over 100 psi per cylinder, with no more than 10 percent variation between the highest and lowest readings. With a compression tester, a few hand tools, and 20 minutes, you can try this yourself.

STEP 1 Remove the fuel pump and fuel-injection fuses. Disconnect the main wire to the coil and spark plug wires; remove spark plugs.

STEP 2 Start the threaded end of the compression gauge in a spark plug hole by hand.

STEP 3 Turn the ignition on, depress the throttle, and crank the engine four revolutions. This should result in a stable reading; if not, crank up to 10 revolutions, but do the same with all cylinders.

STEP 4 Mark the pressure reading for each cylinder on the valve cover in chalk, then move to the next cylinder.

TIP For a cylinder below 100 psi, pour 1 teaspoon of engine oil into the plug hole and retest. If the reading jumps, the piston rings are worn. If not, think valve problems.

Source:
www.youtube.com
www.popularmechanics.com

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.